How To Use Machined Pin/Female Header and IC Sockets

How To Use Machined Pin/Female Header and IC Sockets

The machined pin/female header belongs to one of the categories of pin / Female Header Connector. We should know that the sales volume of machined pin/female header connector in the electronic market is very large and widely used.

If you often deal with connectors, then you will not feel strange to the machined pin/female header bus. It is one of the connector categories. It has a large demand in the component market and is widely used. In order to ensure the round hole pin row female connector more reliable in electronic equipment, we must use the correct method, so as to effectively avoid the occurrence of adverse factors. So in the end, how to use the machined pin/female header connector? Here's how to use the machined pin/female header connector.
To sum up, there are five ways to use the machined pin/female header connector. The details are as follows:

1. When using the machined pin/female header needle and row mother, insert and remove the pin/female header needle and row mother slowly. Especially when pulling out the row needle, do not use too much force to avoid damaging the pin. Pay attention to ensure that both ends of the row needle can come out together.

2. In the installation of machined pin/female header connector, if it is found that the row pin lacks the number of pins, it should be replaced immediately, otherwise it will lead to some problems such as faults in the use of row pin row female connector.

3. It should be noted that in the process of using the machined pin/female header connector, it should not be inserted reversely or misplaced. If the insertion is not smooth, it should not be forced to insert, so as to avoid damaging the row pin.

4. If there are many machined pin/female header connector, we should pay attention to whether the row pins are aligned with the pin holes of the row bus when connecting the row pins with the row bus. Otherwise, if not, once the pin is inserted, it will easily lead to the bending of the row bus.

5. If the use time of round hole row pin is too long, the dust in row pin hole should be removed frequently. Because once the dust accumulation is too large, it will lead to poor contact between the pin and the bus, and there will be some current or signal transmission instability in the use of the bus.

After reading the above, you should be very clear about the use method of the machined pin/female header connector. I hope users can use the above mentioned operation method when using the round hole pin row female connector in the future, so as to ensure the performance reliability of the product to the greatest extent.